OPERATING HEATER
Continued
LIGHTING INSTRUCTIONS
WARNING
•If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fireplace will cause glass to burst. Also if fireplace opening has vents at the bottom, you must open the vents before operat- ing heater.
•You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.
NOTICE
During initial operation of new heater, burning logs will give off a
Note: Homeowners generally prefer to operate their heater with the chimney damper closed. This will put all the heat into the room. However there may be times you will desire the full flames of the Hi heat setting but will find the heat output excessive. You can open the chimney damper (if you have one) fully or partially to release some of the heat. WARNING: Damper handle will be hot if heater has been running.
1.STOP! Read the safety information above.
2.Make sure manual shutoff valve is fully open.
3.Set remote selector switch in the OFF position.
WARNING
Burners will come on automatically within one minute when the remote selector switch is in the ON position.
4. Press in and turn control knob clockwise to the OFF position.
Control Knob | Flame | |
Adjustment | ||
| ||
| Knob |
O | |
IL | T |
P |
|
F
F
O
O
N
O
HI
L
AUTO
OFF
ON
Ignitor Button | Selector Switch in OFF Position |
Figure 21 - Control Knob and Ignitor Button Location
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information above. If you don’t smell gas, go to the next step.
6.Press in and turn control knob counterclockwise to the PILOT position. Press in control knob for five (5) seconds (see above).
Note: You may be running this heater for the first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds or less. This will allow air to bleed from the gas system.
7.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs.
Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting
Procedure on page 20. | Continued |
19
103448