Vanguard Heating VS30PR, VS24PR Unpacking Product Features, Local Codes, Product Identification

PRODUCT IDENTIFICATION

Crossover Log

Top Middle

Log

Left

Front

Branch

Front

Burner

Piezo Ignitor

	HI
MAN	TEMP
AUTO	LO
	ON
	OFF
STATUS

	Right Front
Remote	Branch
	Control Knob
Control
(Optional)	Flame
	Adjustment	Remote
	Knob
		Selector
		Switch
		(Optional)

Figure 1 - VS24PR Shown

Rear Log

Rear

Burner

Bottom

Middle

Log

Base

Assembly

LOCAL CODES

UNPACKING

PRODUCT

FEATURES

4

Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223, also known as NFPA 54*.

*Available from:
American National Standards Institute, Inc.	National Fire Protection Association, Inc.
1430 Broadway	Batterymarch Park
New York, NY 10018	Quincy, MA 02269

Note: Where listed vented decorative logs are required, thermostat operation is not permitted.

1.Remove logs and heater base assembly from carton. Note: Do not pick up heater base assembly by burners. This could damage heater. Always handle base assembly by grate.

2.Remove all protective packaging applied to logs and heater for shipment.

3.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought heater.

Operation

This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing coals. This heater is designed for vent- free operation with flue damper closed. State and local codes in some areas prohibit the use of vent-free heaters.

Safety Pilot

This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS). The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.

Piezo Ignition System

This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.

103448