Lopi Leyden Pellet Stove 2 0Operation, Safety Notice, Location of Controls, Curing the Paint

2 0Operation

Safety Notice

Read this entire manual (especially the "Safety Precautions" on pages 4 and 5) before using this stove. Failure to follow the instructions may result in property damage, bodily injury, or even death.

!Do not unplug the stove to turn it off. This stove relies upon electricity to push the flue gases out the pellet vent – unplugging it may lead to smoke entering your room.

!Failure to maintain your heater will lead to a restricted combustion air system, leading to poor performance and in some cases, smoke spillage into the room. See the "Maintenance" section for details.

Location of Controls

Three tabs are provided on the	Control Panel
back of the stove to hang the
cleaning
tools (bend
the tabs out).

Thermostat or Remote

(required for Auto Operation)

°F

OFF

o

t u A

Starting the Heater for the First Time

Firepot

Restrictor

The restrictor adjusts the amount of air flowing to the firepot.

Start the Heater - Let it Burn for 1 Hour - THEN OPEN THE DOOR

The stove paint is cured through heat. To prevent it from bonding to the door gasket, you must burn the heater for approximately 1 hour, then open and close the door to break any bonding.

Curing the Paint

2 to 4 hours

This stove uses a heat-activated paint that will emit some fumes while starting the first fire. Open doors and windows to the room to vent these fumes. You may also notice oil burning off of the interior of the stove. This rust- stopping agent will soon dissipate.

Priming the Auger

Because of its electronic control panel, this stove does not require priming. If you run out of pellets you may notice it will take approximately 5 minutes longer for the stove to start.

Travis Industries 4061016 1 0 0 - 0 1 1 8 4