Lopi Leyden Pellet Stove 2 2Operation, Manual Mode, To Start, To Shut Down, To Adjust the Heat

2 2Operation

Manual Mode

Manual mode requires the user to turn the heater on and off manually.

To Start

Press the "Manual Start" button. That's it. The stove automatically goes to a medium burn rate and high fan while the igniter starts the fire burning within 10 minutes. During this period the lowest “HEAT OUTPUT” light will flash. If the stove does not start in 30 minutes, the stove turns off.

Once up to temperature, the stove will then run at the heat output setting selected on the control panel (see “To Adjust the Heat” below).

		AUTO
H	UP	OFF
	MANUAL
E
A
T	DOWN	MANUAL
	UP	START

F

AMANUAL

N

DOWN

AUGER

TM

TRAVIS INDUSTRIES

HOUSE OF FIRE

To Shut Down

Move the mode switch to "OFF". The exhaust blower will still run until the heater cools down.

To Adjust the Heat

Press the "Heat” buttons to adjust the heat output.

NOTE: During start-up you may adjust the heat setting. This heat setting will take affect once the start-up sequence is complete.

		AUTO
H	UP	OFF
	MANUAL
E
A
T	DOWN	MANUAL
	UP	START

F

AMANUAL

N

DOWN

AUGER

TM

TRAVIS INDUSTRIES

HOUSE OF FIRE

	DISCONNECT POWER BEFORE SERVICE
H
E	REMOTE
A	HIGH	AUTO
T
O	MANUAL
U
T	AUGER
P
	LOW
U		FAULT
T
		AUTO
H	UP	OFF
	MANUAL
E
A
T	DOWN	MANUAL
F	UP	START
A
N	DOWN
		TM
	TRAVIS INDUSTRIES
	HOUSE OF FIRE

These lights indicate the heat output setting.

NOTE: the lights may be difficult to see from an angle.

Press the “up” or “down” button to adjust the heat output.

Travis Industries 4061016 1 0 0 - 0 1 1 8 4