Vanguard Heating VS18PR, VS24PR, VS30PR Installing Installing Logs, Metal Grate Bar

INSTALLING INSTALLING LOGS
Continued	WARNING

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front logs (#1L and #1R) on top of the grate. Make sure the notches in the bottom of the logs fit over the grate prongs (see Figure 16). Push back of logs flush with metal grate bar. Note: 18" model has only one front log.

2.Rest bottom middle log (#2) behind metal posts on front burner. Make sure the grooves in the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The pegs on the log must be on top (see Figure 17).

3.Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make sure the peg on the log is on top (see Figure 18).

4.Place the top middle log (#4) on the bottom middle log (#2). Make sure the pegs of the bottom middle log fit securely in the holes of the top middle log (see Figure 19).

	Front Log (#1L)	Peg	Bottom Middle Log (#2)
Notch	Front Log (#1R)	Groove	Peg
		Metal Post

Grate
Prongs	Groove

Metal Grate Bar			Metal Post		Grate
Figure 16 - Installing Front Logs			Figure 17 - Installing Bottom
	(#1L and #1R)			Middle Log (#2)
Groo ve	Peg
in Back				Top Middle Log (#4)
of Log	Rear Log (#3)
Grate
Prong		Hole
Rear			Peg
Burner				Hole
		Groove
		in Back
		of Log
		Grate
		Prong
		Bottom
		Middle Log		Peg
				Continued
Figure 18 - Installing Rear Log (#3)			Figure 19 - Installing Top Log (#4)		17

103448