Vanguard Heating VS24PR Optional Ghrct Hand Held Remote Operation Notice, Operating Heater

OPERATING HEATER

Continued

OPTIONAL GHRCT HAND HELD REMOTE OPERATION

NOTICE

You must light the pilot before using the hand-held remote control unit. See Lighting Instructions on page 19.

Control Knob in				Flame Adjustment Knob
On Position
				OL
N			O
O		F
T	F			HI	ON
OLIP
					OFF
					REMOTE

Remote Selector Switch in Remote Position

Figure 23 - Setting the Remote Selector Switch, Control Knob, and Flame Adjustment Knob

for Remote Operation

Note: The GHRCT receiver and hand-held remote control must be purchased separately (see Accessories, page 30). Follow instructions included with the remote control.

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the remote selector switch to the REMOTE position. The burners will come on. You can now turn the burners on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the remote selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

2.Select the MANUAL or AUTO button on the hand-held remote control unit.

•In MANUAL mode, turn burners on or off by pressing the ON or OFF buttons on the hand- held remote control unit.

•In AUTO mode, the room temperature is controlled by the thermostat in the hand-held remote control unit. To increase the room temperature, press the top arrow of the TEMP button. To lower room the temperature, press the bottom arrow to the TEMP button. At higher settings the heater will run more.

IMPORTANT: The hand-held remote control unit must be near the heater. Do not keep the hand-held remote control unit too close the heater. The thermostat on the hand-held remote control unit will heat up too quickly and turn the heater off.

3.Use the STATUS button on the hand-held remote control unit to see the operation mode being used and the temperature setting selected. A red light will come on beside the operation mode being used when the status button is pressed.

4.To turn the burners off when operating in the MANUAL mode, press the OFF button. If operat- ing in the auto mode, press the manual button, then press the OFF button The pilot will remain lit.

IMPORTANT: To turn the pilot off, manually turn the control knob on the heater to the OFF position or set remote selector switch to OFF position.

Shows Temperature Setting

		HI
		TEMP
Allows Burners to be Turned
On and Off with the Hand-
Held Remote Unit.	MAN	LO ON
The log heater will	AUTO	OFF
automatically cycle between
pilot and the heat setting that		STATUS
has been selected.

Increases Room Temperature

Decreases Room Temperature

Turns Burners On and Off

Shows Current Operation Mode

Figure 24 - GHRCT Thermostat Hand-Held Remote Control Unit Selections

103448

21