Silvercrest KH 2380 Installation / Operation, Attaching the control panel, Switching on

Installation / Operation

cinch plug jack [red / rear right] fs.

•Insert the white plug of the cinch connection cable as far as it will go into the LINE IN L cinch plug jack [white / rear left] ft.

•Then insert the 3.5 mm stereo jack into the headphone output of the audio device.

•In order to play back the sound, press the

•LD / MD button buuntil the letters AUX appear in the display window.

•For operation of the external device, please see its operating instructions.

LConnecting to the aerial of the motor vehicle

•Guide the connection cable of the vehicle aerial carefully out of the front of the DIN assembly bracket up to the car radio.

•Insert the plug of the connection cable of the vehicle aerial as far as it will go into the aerial socket goof the car radio.

If necessary, use an aerial adapter in accordance with the technical data of the aerial.

•If present: Connect the 12 V DC connection cable of an electric aerial to the electric aerial fn plug-in.

anchoring plate and the attachment material to the engine fire wall of the vehicle.

•Ensure that all cables are properly connected and that the power supply is working correctly. The LED (red) / power supply dqflashes.

•Use the tip of a ballpoint pen to press the reset button dron the front of the device (see Fig. C).

LAttaching the control panel

•Remove the control panel 1from the plastic box.

•Avoid hard contact with the display window 3.

•Place the rear left-hand edge of the control panel 1on the control panel attachment point dpon the front of the device.

•Ensure that the plug-in connection strip cris positioned in front of the connection socket dl.

•Carefully press the rear right-hand edge of the control panel 1against the control panel attachment point dpuntil it distinctly locks into place.

•Fold the control panel 1upwards and allow it to lock into place.

LAttaching to the DIN assembly bracket

•Insert the rear of the car radio together with the connected cables carefully into the DIN assembly bracket.

•Ensure that no objects are able to cover the vents of the metal housing dt.

•Ensure that there is no connection cable between the metal housing dtand the DIN assembly bracket. Prevent the cables from becoming caught, as any damage may result in a short circuit and malfunctioning of the device or the vehicle’s electronic system.

•Push the car radio into the DIN assembly bracket until it distinctly locks into place.

•You should also secure your device against theft. Fix the attachment screw frwith the

14 GB/IE

LOperation

LSwitching on

•Press the PWR / DIM button cn.

The factory settings of the device are as follows:

•The word [WELCOME] appears in the display window 3.

•The buttons are illuminated in blue (these can be adjusted on two levels).