Operation
GROUND SPEED SELECTOR
Use the Speed Selector (A, Figure 8) to control the drive speed of the snowthrower. There are five forward speeds and two reverse speeds.
Use the lower speeds to blow deep or wet snow. Use the higher speeds to blow light snow or to drive the snow- thrower without blowing snow.
To change speeds, first release the traction Drive Control lever (B, Figure 8), then move the Speed Selector to the desired speed setting. Fully press the traction Drive Control lever to resume operation.
DEFLECTOR
The distance of the discharged snow is mainly controlled by the position of the deflector (Figure 9). (Engine speed also affects distance of discharge.)
The more the deflector is tilted UP, the farther snow will be thrown. Loosen the deflector knob, tilt the deflector UP or DOWN, and then retighten the knob when the desired angle has been chosen.
A | B |
|
Figure 8. Ground Speed Selector
A. Speed Selector
SCRAPER BAR & SKID SHOES
On smooth surfaces such as concrete or asphalt, the scraper bar should scrape the surface. On surfaces such as gravel, the scraper bar should be high enough so that it will not pick up gravel or debris.
The height of the scraper bar is controlled by raising or lowering the Skid Shoes (See Figure 10).
1.To raise the scraper bar height, rest the scraper bar on a strip of wood equal in thickness to the desired height.
2.Make sure the scraper bar is parallel to the ground surface.
3.Loosen the skid shoe nuts and let the skid shoes drop to the surface.
4.Tighten the nuts, making sure the Skid Shoes are adjusted equally and are parallel to the surface.
5.To lower the height of the scraper bar, raise the Skid Shoes.
6.If the scraper bar or skid shoes become worn, they can be replaced by removing the hardware attaching them to the snowthrower.
Chute
Deflector Knob 
Chute
Deflector
Figure 9. Chute Deflector Adjustment
Scraper | Skid Shoe | |
Bar | ||
Nuts | ||
|
Skid Shoe
Figure 10. Skid Shoe Adjustment
03
10
