Simplicity 1693985, 1694439, 1694242, 1693984, 1694435 Starting the Engine, Briggs & Stratton Models

STARTING THE ENGINE

Refer to Figure 4.

1.Turn the fuel valve (B) to the ON position.

2.Insert the engine key (F) into the engine key slot.

3.Move the throttle lever (E) to the FAST position.

4.Fully close the choke (G) if engine is cold (a warm engine may not require choking).

5.Push the primer button (D) two times if engine is cold (a warm engine may not require priming).

6.Pull starter handle (C) rapidly, or push starter button if equipped with the electric start. Do not allow the starter handle to snap back—let the starter rope rewind slowly—while keeping a firm grip on the starter handle.

7.As the engine starts and begins to operate evenly, open the choke (G) slowly and set the throttle lever to SLOW. If the engine falters, turn the choke knob clockwise until the engine runs smoothly, and let it run briefly before returning the choke to the OPEN position.

NOTE: Allow the engine to warm up at SLOW throttle for a few minutes before operating the snowthrower at full speed. The engine will not develop full power until it reaches operating temperature.

			Operation
	Tecumseh Models
B			A
			C
			D
	G	F	E
Briggs & Stratton Models
G	F		B
			E
			A
			C
D

Figure 4. Engine Controls

A.Electric Start Button (Optional)

B.Fuel Valve (Under Tank)

C.Starter Handle

D.Primer Button

E.Throttle Lever

F.Engine Key

G.Choke Knob

13