Features & Controls
|
| Choke |
|
|
| Ground Speed Levers | ||
|
|
|
|
|
|
| ||
Close the choke for cold starting. Open the choke |
| These levers control the ground speed of the rider. | ||||||
once the engine starts. A warm engine may not |
| |||||||
| The left lever controls the left rear drive wheel and the | |||||||
require choking. Pull the knob UP to close the choke. | ||||||||
right lever controls the right rear drive wheel. | ||||||||
Push to knob DOWN to open the choke. |
| |||||||
| Moving a lever forward increases the FORWARD | |||||||
|
|
|
|
|
| |||
|
| PTO (Power Take Off) Switch |
| speed of the associated wheel, and pulling back on a | ||||
|
|
| lever increases the REVERSE speed. | |||||
The PTO switch engages and disengages the mower. | ||||||||
Note: The further a lever is moved away from the | ||||||||
Pull UP on the switch to engage, and push DOWN to | ||||||||
neutral position the faster the drive wheel will turn. | ||||||||
disengage. |
|
| ||||||
|
| See the Operating the Zero Turn Rider section for | ||||||
|
| Ignition Switch |
| |||||
|
|
| steering instructions. | |||||
|
|
|
|
|
| |||
The ignition switch starts and stops the engine, it has |
| Fuel Tank Cap | ||||||
| ||||||||
three positions: |
|
|
| |||||
|
|
|
| |||||
|
|
| OFF | Stops the engine and shuts off the |
| To remove the cap, turn counterclockwise. | ||
|
|
|
| |||||
|
|
|
|
|
| |||
|
|
|
| electrical system. |
|
|
| |
|
|
| RUN | Allows the engine to run and powers t |
| Fuel Level Gauge | ||
|
|
|
| |||||
|
|
|
| Reproduction | ||||
|
|
|
| the electrical system. |
| Displays the fuel level in the tank. | ||
|
|
| START | Cranks the engine for starting. |
| |||
|
|
| for | |||||
|
|
|
|
| ||||
|
|
|
|
| ||||
NOTE: Never leave the ignition switch in the RUN position with the engine
The throttle controls engine speed. MoveNotthe thr ttle forward to increase engine speed and back to decrease engine speed. Always operate at FULL throttle.
Hour Meter / Maintenance Reminder
Measures the time of the PTO being engaged. The hour meter measures the number of hours the PTO has been engaged. The hour meter will flash an initial oil change indicator at 5 hours, and a lubrication reminder every 50 hours. These reminders display for approximately two hours and will automatically reset themselves.
Note: The hour meter will register the passage of time only when the PTO is engaged. The hour meter has a self contained power source so the total hours are always visible.
Headlight
The headlight switch turns the headlights on and off.
Seat Adjustment Lever
The seat can be adjusted forward and back. Move the lever towards the left, position the seat as desired, and release the lever to lock the seat in position.
Controls
15