MAINTENANCE
SEAT ADJUSTMENT
The seat and ground speed control levers should be adjusted so that operator’s elbows are supported by the arm rests when his/her hands are on the controls, and the ground speed control levers can be moved through their full range of motion without contacting the operator’s legs.
Seat Position Adjustment |
| |
The seat can be adjusted forward and back. Move | A | |
the adjustment lever (A, Figure 23) towards the left | ||
| ||
hand side of the machine, slide the seat to the desired |
| |
position, and release the lever. |
| |
| Figure 23. Seat Adjustment | |
| A. Adjustment Lever |
GROUND SPEED CONTROL LEVER | C | |
ADJUSTMENT | ||
|
| Reproduction |
| ||||
The control levers can be adjusted in three ways. The |
|
|
|
| ||
alignment of the control levers, the placement of the |
|
|
|
| ||
levers (how close the ends are to one another) and |
|
|
| A | ||
the height of the levers can be adjusted. |
|
|
| B | ||
| To Adjust the Handle Alignment: Loosen the mount |
|
|
| |||
bolts (A, Figure 24) and pivot the lever(s) (C) | o align | for |
|
| ||
with each other. |
|
|
|
| ||
| To Adjust the Handle Placement: Loosen the jam |
|
|
|
| ||
nuts and adjust the placement bolt (B, Figure 24) in or | Figure 24. Control Lever Adjustment |
| ||||
out to properly adjust the lever end spacing. |
|
| A. Alignment Hardware |
| ||
| To Adjust the Handle Height: RemoveNotthe mounting |
| |||||
| B. Placement Hardware |
| |||||
hardware and reposition the handle either up or down |
| C. Ground Speed Control Lever |
| |||
from its original position. You will need to readjust the |
|
|
| |||
handle alignment as described above. |
|
|
|
|
| |
30 | www.simplicitymfg.com www.snapper.com |