TROUBLESHOOTING
Rider Troubleshooting Continued.
| PROBLEM | CAUSE | REMEDY |
| ||
| Engine runs, but rider will | 1. | Hydraulic release valve(s) | 1. | Turn valve(s) clockwise to close. |
|
| not drive. |
| in “open” position. |
|
|
|
|
| 2. | Belt is broken. | 2. | See Drive Belt Replacement. |
|
|
| 3. | Drive belt slips. | 3. | See problem and cause below. |
|
|
| 4. | Brake is not fully released. | 4. | See authorized service dealer |
|
|
|
|
|
|
|
|
| Rider drive belt slips. | 1. | Pulleys or belt greasy or oily. | 1. | Clean as required. |
|
|
| 2. | Tension too loose. | 2. | Adjust spring tension. |
|
|
|
|
|
| See Drive Belt Replacement |
|
|
| 3. | Belt stretched or worn. | 3. | Replace belt. |
|
|
|
|
|
|
|
|
| Brake will not hold. | 1. | Brake is incorrectly adjusted. | 1. | See Brake Adjustment. |
|
|
| 2. | Brake pads worn. | 2. | Replace with new brake pads. |
|
|
|
|
|
|
|
|
| Rider steers or handles poorly. | 1. | Steering linkage is loose. | 1. | Check and tighten any loose connections. |
|
|
| 2. | Improper tire inflation. | 2. | See Regular Maintenance Section. |
|
TROUBLESHOOTING THE MOWER
| PROBLEM | CAUSE |
|
| REMEDY |
| ||
|
|
| for |
|
|
| ||
| Mower will not raise. | Reproduction |
| |||||
| 1. | Lift linkage not prope ly attached | 1. | See authorized service dealer for repair. |
| |||
|
|
| or damaged. |
|
|
|
|
|
| Engine stalls easily with | 1. | Engine speed t | sl | w. | 1. | Set to full throttle. |
|
| mower engaged. | 2. | Ground speed t | ast. | 2. | Decrease Ground Speed. |
| |
|
| 3. | Cutting height set t | l w. | 3. | Cut tall grass at maximum cutting |
| |
|
|
|
|
|
|
| height during first pass. |
|
|
| 4. | Discharge chu e jamming | 4. | Cut grass with discharge pointing toward |
| ||
|
|
| with cut grass. |
|
|
| previously cut area. |
|
| Excessive mower vibration. | 1. | Blade m unting bolts are loose. | 1. | Tighten to 70 ft.lbs. (94 Nm). |
| ||
|
| 2. | Mower blades, arbors, | 2. | Check and replace as necessary. |
| ||
|
|
| or pulleys are bent. |
|
|
|
| |
|
| Not3. Mower blades a e |
| ut | 3. | Remove, sharpen, and balance blades. |
| |
|
|
| of balance. |
|
|
| See Maintenance Section. |
|
|
| 4. | Belt installed inco | ectly. | 4. | Reinstall Correctly. |
| |
|
|
|
|
|
|
| ||
| Excessive belt wear or breakage. | 1. | B nt or rough ulleys. | 1. | Repair or replace. |
| ||
|
| 2. | Using incorrect belt. | 2. | Replace with correct belt. |
| ||
|
|
|
|
|
|
| ||
| Mower drive belt slips | 1. | Idl r pull y spring broken or not | 1. | Repair or replace as needed. |
| ||
| or fails to drive. |
| properly attached. |
|
|
|
|
|
|
| 2. | Mower drive belt broken. | 2. | Replace drive belt. |
| ||
|
|
|
|
|
|
| ||
| Mower does not engage. | 1. | Electrical wiring damage. | 1. | Locate & repair damaged wire. |
| ||
|
| 2. | Battery voltage too low. | 2. | Recharge battery and check alternator. |
| ||
|
|
|
|
|
|
| See Battery Maintenance section. |
|
40 | www.simplicitymfg.com www.snapper.com |