Simplicity H924RX manual Children, Clearing a Clogged Discharge Chute, Emissions

en

18.Never direct discharge at bystanders or allow anyone in front of the unit.

19.Never leave a running unit unattended. Always disengage the auger and traction controls, stop engine, and remove keys.

20.Do not operate the unit while under the influence of alcohol or drugs.

21.Keep in mind the operator is responsible for accidents occurring to other people or property.

22.Data indicates that operators, age 60 years and above, are involved in a large percentage of power equipment−related injuries. These operators should evaluate their ability to operate the unit safely enough to protect themselves and others from injury.

23.DO NOT wear long scarves or loose clothing that could become entangled in moving parts.

24.Snow can hide obstacles. Make sure to remove all obstacles from the area to be cleared.

Children

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the unit and the operating activity. Never assume that children will remain where you last saw them.

1.Keep children out of the area and under the watchful care of another responsible adult.

2.Be alert and turn off if children enter the area.

3.Never allow children to operate the unit.

4.Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision.

Clearing A Clogged Discharge Chute

Hand contact with the rotating impeller inside the discharge chute is the most common cause of injury associated with snowthrowers. Never use your hand to clean out the discharge chute.

To clear the chute:

1.SHUT OFF THE ENGINE.

2.Wait 10 seconds to be sure the impeller blades have stopped rotating.

3.Always use a clean out tool, not your hands.

2.Never store the machine with fuel in the tank inside a building where ignition sources are present such as hot water and space heaters, or clothes dryers. Allow the engine to cool before storing in any enclosure.

3.Always refer to operator’s manual for important details if the snowthrower is to be stored for an extended period.

4.Maintain or replace safety and instruction labels as necessary.

5.Run the machine a few minutes after throwing snow to prevent freeze−up of the collector/impeller.

6.If fuel is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until fuel vapors have dissipated.

7.Always observe safe refueling and fuel handling practices when refueling the unit after transportation or storage.

8.Always follow the engine’s manual instructions for storage preparations before storing the unit for both short and long term periods.

9.Always follow the engine manual instructions for proper start-up procedures when returning the unit to service.

10.Keep nuts and bolts tight and keep equipment in good condition.

11.Never tamper with safety devices. Check their proper operation regularly and make necessary repairs if they are not functioning properly.

12.Components are subject to wear, damage, and deterioration. Frequently check components and replace with manufacturer’s recommended parts, when necessary.

13.Check control operation frequently. Adjust and service as required.

14.Use only factory authorized replacement parts when making repairs.

15.Always comply with factory specifications on all settings and adjustments.

16.Only authorized service locations should be utilized for major service and repair requirements.

17.Never attempt to make major repairs on this unit unless you have been properly trained. Improper service procedures can result in hazardous operation, equipment damage and voiding of manufacturer’s warranty.

Emissions

1.Engine exhaust from this product contains chemicals known, in certain quantities, to cause cancer, birth defects, or reproductive harm.

2.If available, look for the relevant Emissions Durability Period and Air Index information on the engine emissions label.

Service, Maintenance And Storage

Ignition System

1.Check shear bolts (pins) and other bolts at frequent intervals for proper tightness to be sure the equipment is in safe working condition.

1. This spark ignition system complies with Canadian ICES-002.

1742227 8