Simrad RGC12 manual Logistics, Terminal connector tool

Installation Manual

3.3 Logistics

Safety: Refer to general safety procedures

Personal qualifications: Trained mechanical workers

Minimum number of personnel: 1

Ship location: No recommendations

Special tools required: Terminal connector tool supplied with equipment

3.4 Terminal connector tool

All terminal connections are by self locking crimp terminals.

A special connector tool is located in a plastic bag inside the Control Box.

Insert the tool such that the hook enters the slot above the cable entry. Press down the shaft to open the wire lock mechanism and insert the wire. Release the pressure and lift out the tool. The wire is now locked and secured.

3.5Caution in Installation

1.Install the RGC12 Master Compass so that horizontal base datum lines coincides with the ship’s fore and aft line. See Figure 4-1,page 17.

2.Ensure that the service space shown in the installation drawing is provided. See Figure 4-2,page 18.

3.Install the RGC12 Control Box at a convenient place easy to operate and easy to access for inspection and service.

4.Since the spring-pressure type terminal boards are applied in the Control Box for cable connections, do not connect several wires to one terminal.

20220737B 13