![](/images/new-backgrounds/1258734/25873411x1.webp)
TOOL ASSEMBLY
WARNING!
To reduce the risk of injury, always unplug tool before attaching or removing accessories or making adjustments. Use only specifically recommended accessories. Others may be hazardous.
Installing Guard (Fig. 1)
Fig. 1 | Guard | Spindle |
Hex bolt
1.Place the tool on a firm surface with the spindle hub facing up.
2.Loosen the hex bolt on the guard with the allen wrench provided with the tool.
3.Slide the guard over the spindle hub and tighten the hex bolt with the allen wrench.
To change wheels:
1.To install
2.Slide the back flange,
3.Tighten nut securely with the wrench provided with tool.
NOTE: Nut has a left hand thread. To tighten, turn nut in a counter- clockwise rotation.
4.To remove
Installing and Removing Shoe (Fig. 3)
Fig. 3
Wing nuts
WARNING!
To reduce the risk of injury, use only the proper wheel made for this tool. DO NOT USE ANY TYPE OF SAW BLADE. USE ONLY TYPE “1” ABRASIVE AND DIAMOND WHEELS.
Removing and Installing
Before operating the tool, make sure the wheel is in good condition as described (see “Special Safety Instructions -
Fig. 2 | Nut |
| |
| Top flange |
1.To install shoe assembly, loosen wing nuts on shoe assembly.
2.Place the first bolt head into the hole on the guard. Angle shoe assembly as shown, to place the second bolt.
3.Adjust shoe to proper height and tighten wing nuts securely.
4.To remove shoe assembly, loosen wing nuts and slide shoe assem- bly so that both bolts can be removed from holes in guard.
Installing Side Handle
1.To install handle, place tool on guard side.
2.Align bolts with threaded holes in gear case and tighten securely.
Cutting wheel
Back flange
Spindle
page 6