4
5
1. Connect the USB cable to the
USB port at the rear of the
SpeedStream® device (blue port).
2. Connect the other end to the USB
port on your computer.
3. Plug the DSL cable (RJ-11) into the
DSL port on the SpeedStream® device.
4. Plug the other end of the cable
(RJ-11) into the phone jack.
5. Plug the power adapter into the
power outlet and SpeedStream®
device.
6. Ensure the SpeedStream® device is
powered on (power switch located
on right side of back panel).

Connect the SpeedStream® Device

You have completed the installation of your SpeedStream
®
DSL hardware.
Install the USB driver software on your PC using one of the procedures below.
Internet connection
RJ-11 DSL cable
USB connection
to computer
Power supply
1
2
3
4
6
5

Software Installation

Before installing the software, make sure your Mac is running OS 8.6 or above. This procedure
will restart your computer to complete the installation.
1. Insert the SpeedStream
®
Installation CD into your CD-ROM drive.
2. Open the SpeedStream
®
Icon from the desktop.
3. Click Readme.txt.
4. Follow the directions in the Readme.txt to complete the software installation.
5.
After the USB driver is installed, continue with PC Conguration Procedures described
on the next page.

Software Installation

You will need to install USB drivers if you are connecting the SpeedStream® device to your computer
via the USB port.
Before installing the software, make sure your PC is equipped with the following:
Windows® 98, Windows® 98 Second Edition (SE), Windows® 2000 Professional, Windows® Millennium Edition
(Me), or Windows® XP; 32 MB RAM; Pentium-compatible 166 MHz or faster processor; 12 MB available
hard disk space.
1. Insert the SpeedStream® Installation CD into your CD-ROM drive. This will
automatically start the software installation program. Follow the on-screen
directions to complete the software installation.
2. After the USB driver is installed, continue with PC Conguration Procedures
described on the next page.
If the software installation program does not automatically start, you can manually start it using the
following procedure.
1. Click Start > Run.
2. Browse to setup.exe on the CD and double-click it. This will start the software installation program.
3. Follow the on-screen directions to complete the software installation.
Option B > USB Installation Method
Windows USB Driver Installation
Macintosh USB Driver Installation