2)Use extra deep sockets in place of extension bars where possible.
3)Do not use oversized, worn or cracked sockets.
4)Hold the wrench so the socket fits squarely on the fastener. Hold the wrench firmly, but not too tightly, pressing forward slightly.
Dismantling & Assembly Instructions
Disconnect tool from air supply.
Unscrew hammer case cap screws (38) and take off hammer case (36). Take out hammer case pilot (35) and anvil (39, 39B or 39C) from hammer case (36). Release hammer (34) by removing hammer pin (33), then take off hammer frame rear washer (19) and motor clamp washer (31).
Grip or support housing (1) and shake up and down to allow cylinder
(24)to fall free. Take off front end plate (28), cylinder dowel (25), cylinder (24) and 6 rotor blades (27) in order. Unscrew rear rotor bearing retainer (23) and take out rotor (20).
Grip motor housing (1) and tap out trigger pin (9) by using a 3.5 mm suitable pin. Remove reverse valve knob screw (16) to take off reverse valve knob (15) and drive reverse valve (12) from reverse valve bushing (10). Be careful not to loose reverse valve detent ball (13). Turn air inlet bushing (6) and pull out valve spring (4), throttle valve bushing (2) and throttle valve stem (5).
Reassembly
Clean all parts and examine for wear, etc., and replace any parts excessively worn with only parts obtained from the manufacturer or an approved distributor. Lightly coat all parts in a suitable pneumatic tool lubricating oil and pack bearings and gears with a lithium or molybdenum based general purpose grease and reassemble in the reverse order.
Operation Specification
|
| 5000A/5000AP | 5000AL |
Air Consumption |
| 4.2 cfm (30 scfm) | |
Maximum Torque |
| 425 ft.lbs. (578 Nm) | |
Operating Torque |
| ||
Air Inlet Thread |
| ||
Overall Length |
| 7.3" (185 mm) | 9.3" (236 mm) |
|
|
|
|
| at 90 PSIG/6.2 bar |
| |
Notes
DECLARATION OF CONFORMITY
Sioux Tools Inc.
250
declare under our sole responsibility that the products
Model 5000A/5000AL/5000AP Impact Wrenches, Serial Number
to which this declaration relates are in conformity with the following standard or standards or other normative document or
documents:
EN 792, EN 292 Parts 1& 2, ISO 8662 Parts 1 & 7, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Mark S. Pezzoni (President Power and Specialty Tools)
Name and signature or equivalent marking of authorized person
Printed in Taiwan
Page No 3
