Skil 3600 manual Motor Specifications and electrical Requirements, Double insulated Tools

motor Specifications and electrical Requirements

General Specifications		extension cords
Voltage Rating	120 V, 60 Hz	Replace damaged cords immediately. Use of damaged
		cords can shock, burn or elec trocute.

Amperage Rating . . . . . . . . . . . . . . . . . . . . . . . .7 A

No Load Speed . . . . . . . . . . . . . . . . . .no 11,000/min

Table size . . . . . . . . . . . . . . . . . . . . . . .27” x 17-3/4”

Always use proper extension cord. If an extension cord is necessary, a cord with adequate size con ductors should be used to prevent excessive voltage drop, loss of power or over- heating. The table shows the correct size to use, de pending on cord length and nameplate amperage rating of tool. If in doubt, use the next heavier gauge. Always use U.L. and CSA listed extension cords.

Double insulated Tools

Double Insulation        is a design concept used in elec rict power tools which eliminates the need for the three wire grounded pow er cord and grounded power supply system. It is a recog nized and approved system by Underwriter’s Lab- oratories, CSA and Federal OSHA authorities.

impoRTANT: Servicing of a tool with double insulation re- quires care and knowledge of the system and should be performed only by a qualified service technician.

WHEN SERVICING, USE ONLY IDENTICAL REPLACE- MENT PARTS.

POLARIZED PLUGS. To reduce the risk of electric shock, your tool is equipped with a po arl zedi plug (one blade is wider than the other), this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. To reduce the risk of electric shock, do not change the plug in any way.

RecommeNDeD SiZeS of eXTeNSioN coRDS 120 VolT AlTeRNATiNG cURReNT ToolS

Tool’s	cord Size in A.W.G.				Wire Sizes in mm2
Ampere
	cord length in feet				cord length in meters
Rating
	25	50	100	150	15	30	60	120
3-6
	18	16	16	14	.75	.75	1.5	2.5
6-8	18	16	14	12	.75	1.0	2.5	4.0
8-10	18	16	14	12	.75	1.0	2.5	4.0
10-12	16	16	14	12	1.0	2.5	4.0	—
12-16	14	12	—	—	—	—	—	—

NoTe: The smaller the gauge number, the heavier the cord.

“SAVe TheSe iNSTRUcTioNS”

7.