Skil MAG77LT manual Maximum Depth of CUT Stability, SET Screw Wrench Usage

SM 1619X04759 11-12_SM 1619X04759 11-12.qxp 11/20/12 2:05 PM Page 11

MAXIMUM DEPTH OF CUT STABILITY

ADjUSTMENT

Note; Feature is set during assembly. Adjustment may be required due to wear and tear on the tool.

Disconnect plug from power source. Set tool to zero bevel. Place tool on foot plate onto a level surface with rear of foot over hanging work bench by about 2 inches. Loosen the depth adjustment lever. Set tool to maximum depth of cut. If the adjustment set screw is in contact to the motor housing prior to achieving maximum depth of cut then lower set screw using a 3/16” Allen wrench until maximum depth of cut is reached. If set screw is not in contact with motor housing when maximum

depth of cut is reached then raise the set screw until it just engages the motor housing (Fig 7).

FIG. 7

SET SCREW

WRENCH USAGE

Wrench provided has several functions other than loosening/tightening the blade bolt (Fig. 8).

1.Loosening/tightening blade bolt (1/2” wrench)

2.Loosening/tightening combo oil plug/lock button assembly (1/2” wrench)

3.Loosening/tightening brush caps (slotted driver)

4.Loosening/tightening bevel/depth levers when levers are over tightened or additional tightening is needed (9/16” wrench)

5.Blade diamond arbor knock out (wedge feature)

Storage is provided on the tool (Fig. 1A). Wrench is fully seated when second lock detent is engage. Wrench needs to be inserted with the correct orientation (Fig. 9). Damage to work piece could occur if inserted incorrectly.

1/2" WRENCH		WEDGE
	FEATURE

FIG. 8

2 1

3 4

5

9/16" WRENCH

SLOTTED

DRIVER

FIG. 9

CORRECT

INCORRECT

-11-