Function Menu Operation
Function Menu Operation
TV Source
Press VOL+ button to enter TV Source menu.
In TV Source menu, you can switch TV source among Antenna, Cable(STD), Cable(IRC) and Cable(HRC) by pressing VOL+ button.
Please make it sure that proper TV Source is selected before auto scan is started otherwise programs may not be found and stored.
Skip
Press VOL+/VOL- buttons to switch on or switch off the skip function. If skip function is on, you can not watch the corresponding program by pressing CH+/CH- buttons. While you can watch this program by entering the channel number directly.
Fine Tune
Try this function if TV image is not good. The adjustable frequency range is + 625KHz. Note:
AFT(Automatic frequency tune) function is also available. TV set will adjust the frequency of TV signal automatically to obtain the best effect unless you adjust frequency through Fine Tune function manually.
Auto Scan
Press VOL+ button to search and store all available programs automatically.
Note:
TV set will store programs of cable and antenna systems separately. Connect cable to your TV set, switch to cable system through TV Source item. Available programs will be stored through channel No.1 to channel No. 125. Then Connect antenna to your TV set, switch to antenna system through TV Source item. Available programs will be stored through channel No.2 to channel No. 69.
PC Setup menu
You can modify settings on PC input in this menu Press CH+/CH- buttons to select available items
in this menu and perform corresponding operation.
Note:
You can enter this menu only in PC input and there is valid signal for the PC input.
Auto Adjust
Press VOL+ button to start adjust PC settings automatically. It will take a few seconds to finish the adjustment including horizontal and vertical position, phase and clock of the PC image. If you are not satisfied with the effect, you can adjust these settings manually through following functions
HPos and VPos
Adjust the position of the PC image through these items by pressing VOL+/VOL- buttons. Adjust the position of PC image horizontally through HPos item and adjust the position of PC image vertically through VPos item.
Phase
Adjust the phase of the PC image by pressing VOL+/VOL- buttons. It will make the image sharp or blurry
Clock
Adjust the clock of the PC image by pressing VOL+/VOL- buttons. It will change the width of the active image of the PC input.
Note:
Supported PC input format includes:
MODE | Resolution | Vertical | |
Frequency | |||
|
| ||
VGA | 640X480 | 60Hz | |
SVGA | 800X600 | 60Hz | |
XGA | 1024X768 | 60Hz | |
|
|
|
Other formats may be supported by the TV set.
15
