Pelco dx8100 manual Setting Up the E-mail Server, Basic E-mail Notification Setup

Setting Up the E-mail Server

Set up the e-mail server in the Emergency E-Mail Notification page. For information about accessing the Emergency E-Mail Notification page, refer Accessing the Emergency E-mail Notification Setup on page 238.

To set up the e-mail server:

1.On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.

2.Click the Notification button . The Notification page is displayed.

3.Click the Emergency E-mail Notification Setup tab.

4.Enter a name in the Full Name box. You should enter a name that reflects the DX8100 server sending the notification (for example, DX8100 First Floor Lobby). Names can be up to 31 characters long and can include spaces. but not special characters.

5.Enter your e-mail address in the E-mail Address box.

6.Enter the address of your local SMTP mail server. Obtain this information from your network administrator.

7.If your e-mail server requires you to log in, do the following:

a.Select the check box labeled My E-mail Server Requires Authentication.

b.Enter your e-mail server address.

c.Enter your user name. (User names can be up to 31 characters in length and cannot include spaces or special characters.)

d.Enter your password. (Passwords can be up to 19 characters in length and cannot include spaces or special characters.)

8.Click Apply.

￿ ￿

￿

￿

￿

Figure 179. Basic E-mail Notification Setup

C2630M-C (7/09) 239