Pelco dx8100 Deleting Clients from the Notification List, Setting Server Event Transmission Time

DELETING CLIENTS FROM THE NOTIFICATION LIST

To delete a client from the emergency notification list:

1.On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.

2.Click the Notification button . The Notification page is displayed.

3.Do the following:

a.In the Emergency Agent Setup section, select a client from the list.

b.Click Delete. The selected client is deleted.

4.Click Apply.

LINKING CAMERAS TO CLIENT EMERGENCY AGENTS

After clients have been added, cameras must be configured to notify individual clients about an event. A single camera can be linked to one or more client emergency agents.

Up to 32 IP addresses can be assigned to each camera. The DX8100 can transmit up to 10 IP addresses simultaneously.

To link a camera to one or more clients:

1.On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.

2.Click the Notification button . The Notification page is displayed.

3.In the Camera Setup section, click a camera button (Camera 1-32). The Emergency Agent Selection dialog box opens.

4.Click the check box to select the name of the client site you want to notify when a motion, alarm, or video loss event is detected by this camera.

5.Repeat steps 1 and 2, for up to 32 cameras on the current site.

6.Click the Apply button at the bottom of the screen.

7.Configure the server event transmission time. For information about setting the duration and transmission interval, refer to Setting Server Event Transmission Time on page 237.

SETTING SERVER EVENT TRANSMISSION TIME

After clients have been added and linked to cameras, you must set the amount of time a server sends images after an event occurs and the interval between sending each image (for one of more clients). For information about adding clients, refer to Adding Client Emergency Agents to be Notified on page 236. For information about linking cameras, refer to Linking Cameras to Client Emergency Agents on page 237.

To set the duration for sending images and the transmission interval:

1.On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.

2.Click the Notification button . The Notification page is displayed.

3.In the Option section of the Emergency Agent page, enter the amount of time (in seconds) that you want the DX8100 to continue sending still images after an alarm, motion, or video loss event has been detected.

4.Enter the time interval (in seconds) that you want the DX8100 to wait between sending each still image.

5.Click Apply.

C2630M-C (7/09) 237