Pelco dx8100 manual Programming a Pattern

PROGRAMMING A PATTERN

This section describes how to program a pattern. Certain PTZ devices, such as Pelco’s Spectra series domes, will display an on-screen message stating the amount of remaining memory available for pattern programming.

Start Programming a Pattern

To program a pattern:

1.On the PTZ keypad toolbar, click the Live button .

2.Drag a camera from the Site Tree onto a view panel.

3.On the PTZ keypad, click the Set button to enter programming mode.

4.Using the PTZ keypad, select a number for the pattern (1-4).

5.Click the Pattern button .

6.Move the camera through a series of movements using the on-screen PTZ and focus controls.

￿

￿

￿

Figure 26. Programming a Pattern

Stop Programming a Pattern

To stop programming a pattern:

1.On the PTZ keypad, click the Pattern button .

2.Click the Set button .

56 C2630M-C (7/09)