Setting Up RS-422/RS-485 Communication Port Properties
The DX8100 interfaces with the KBD300A, ATM/POS, and
To configure Port 1 to Port 4 properties:
1.In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2.In the Communication Port
3.In the device
ATM/POS devices can use COM1 and Port 1 to Port 4. The KBD300A and
4.Configure the following port settings using the
•Interface mode
•Baud rate
•Parity
•Data bits
•Stop bits
5.Click Apply.
SETTING UP ATM/POS DEVICE PROPERTIES
The DX8100 allows you to connect up to 16 ATM/POS devices and provides 2 ATM/POS device modes:
•Single Mode: Use this option to connect up to 4 ATM/POS devices to the DX8100.
•Multi Mode: Use this option to connect up to 16 ATM/POS devices to the DX8100 over one serial connection.
Single Mode and Multi Mode can be combined to connect up to 16 ATM/POS devices to the DX8100. For information about installing the ATM/POS equipment for each mode, refer to the DX8100 Installation manual.
This section describes how to configure ATM/POS device properties and includes the following topics:
•Selecting the ATM/POS Device Mode and Communications Options
•Setting Up an ATM/POS Data Format
•Assigning a Data Format to an ATM/POS Device on page 190
•Setting Up ATM/POS Exceptions on page 191
•Verifying the ATM/POS Communication Connection on page 196
•Recording ATM/POS Events on page 197
180 |