Pelco dx8100 manual Configuring KBD300A Communication Settings, Control Action

•Configure the KBD300A communication settings

Configuring KBD300A Communication Settings

This section describes how to configure the KBD300A communication settings. The KBD300A is interfaced to the DX8100 using Port 1 to Port 4. These ports support connectivity to the DX8100 using the RS-422 data communication standard. A user-supplied RJ-45 cable is required. For information about using the KBD300A, refer to Using the KBD300A Keyboard on page 66.

To configure the KBD300A communication settings:

1. Connect the KBD300A to the DX8100 to a RS-422 RJ-45 port.

1.On the DX8100 toolbar, click the Setup button . The Setup dialog opens to the Camera page.

2.In the Setup dialog box, click Network button . The Network page is displayed.

3.In the Network page, click the Port/Device tab. The Port/Device page is displayed.

4.In the Communication Port drop-down box, select the Port to which the KBD300A is connected.

5.In the device drop-down box, select KBD300A (Pelco).

6.Configure the following port settings.

•Interface mode: RS-422

•Baud rate: 9600

•Parity: ODD

•Data bits: 8

•Stop bits: 1

7.Click Apply.

KBD300A Standard Mode Operational Features

Table AY describes the KBD300A Standard Mode operational features.

	Table AY. KB300A Standard Operational Mode Features
Control	Action
Joystick	Controls the camera’s PTZ operation.
Number + PRESET (short)	Moves camera to the programmed preset position.
Number + PRESET (long)	Programs the current camera position to the desired preset number.
Number + PATTERN (long)	Starts the pattern record mode.
ACK	Stops the pattern record mode.
Number + PATTERN	Runs the desired pattern.
Number+ AUX ON/AUX OFF	Turns the specified auxiliary output on or off.
Number + MON	Assigns the selected camera to the desired view pane. The active view pane is highlighted.

C2630M-C (7/09) 199