Pelco dx8100 manual Modifying a Sequence Instance in the List, Click No to the Append option

e.Click No to the Append option.

3a

3c 3b 3d

Figure 176. Loading a Mapping Sequence

Modifying a Sequence Instance in the List

To modify a sequence instance in the list:

1.On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.

2.Click the Ext. Monitor button . The External Output page is displayed.

3.In the Manual Camera Mapping Mode section, do the following:

a.Click the button (if it is not selected) to select the Manual Camera Mapping mode.

b.Click one of the sequence instances from the list.

c.Select a screen division.

d.Drag cameras from the Site Tree onto each view panel until cameras have been assigned to all panels.

e.From the Min and Sec drop-down boxes, select the amount of time the sequence instance will remain on the monitor.

f.Click Modify.

g.Click Save.

The Save dialog box open.

4.Select an existing profile or enter a new profile name under which to save the sequence list.

5.Click OK.

6.Click Apply.

232 C2630M-C (7/09)