To set up video loss detection:
1.On the DX8100 toolbar, click the Setup button 
. The Setup dialog opens to the Camera page.
2.In the Video Loss Detection section, do one or both of the following:
•Click the “Loss of synchronization” check box.
•Click the “Low level of video” check box.
•In the Low Level of Video Detection Operation Time section, set the Start Time and the End Time.
3.Click Apply.
Figure 89. Video Loss Detection
APPLYING SETTINGS TO ALL CAMERAS
If you want to keep the changes you made to options and parameters on the Camera page, you must click Apply. If you attempt to leave the Camera page, the system will display a message box, prompting you to apply, not apply, or cancel the changes.
To apply camera configuration options to all attached cameras:
1.On the DX8100 toolbar, click the Setup button 
. The Setup dialog opens to the Camera page.
2.Perform the camera configuration.
3.In the Apply to All Cameras section, select the check boxes for one or more of the settings you want to apply to all cameras: Protocol, Camera Security, Picture Adjustment, Motion Detection, Audio Settings, and Video Loss.
4.Click Apply to All Cameras.
5.Click Apply.
IP CAMERA SETUP
This section describes how to configure IP cameras and is organized into the following sections:
•Configuring the DX8100 to Record IP Camera Video on page 123
•Disabling an IP Camera on page 130
•Deleting an IP Camera on page 131
•Restoring a Disabled Analog or IP Camera on page 131
For information about the supported IP cameras, refer to the DX8100 Series HVR Version 2.0 Release Notes. To access this document, go to http://www.Pelco.com and navigate to the Hybrid Video Recorders page.
122 |
