Quickstart Guide
If you already have an Ethernet LAN and a machine to use as the server, setting up the SliMP3 will take you just a few minutes, and all you will need is this quick start guide - each step is boldfaced, followed by a brief explanation.
Setting up the player
Connect the Ethernet port to your hub using a standard RJ45 patch cord
Connect the player your Ethernet hub or switch using the included CAT5 patch cord. If you are connecting it directly to the Ethernet card in your server machine, use a crossover cable.
Connect the player's RCA outputs to the inputs on your receiver
The player has a pair of standard, line level, RCA audio output jacks - connect these to the inputs on your amplifier, receiver, or powered speakers.
Configure the IR remote: press "S, DVD, 0, 0, 7, ENT, DVD"
A Sony
The SliMP3 uses the IR codes for a JVC brand DVD player - we chose to use the JVC codes because we wanted to use an
See the instruction manual that comes with the remote for more information on its additional features.
Connect the power supply
The SliMP3 comes with a 5V, 1600ma switching power supply. Please be careful to use ONLY this power supply - connecting a different power supply may damage the player, and such damage is not covered by warranty.
The player can be left plugged in at all times. When not in use, it enters a "standby" mode, powering down the display and drawing only a few milliamps.
Enter the IP address information
When the player is first powered up, it asks you if you want to configure it. If your network supports DHCP, the player can configure itself completely automatically. Otherwise, you can manually enter static IP addresses. Use the UP/DOWN buttons to choose either DHCP or static, and then press
RIGHT.
4
