Power light Service light Message
Off Solid red The projector has a fan issue. It could shut down
automatically.
See The “Fan Failure” message appears on the next page to
troubleshoot the projector.
Off Solid red The projector has a color wheel issue.
See The “Color Wheel Failure” message appears on the
next page to troubleshoot the projector.
Solid red Flashing red The projector has a lamp issue.
See The “Lamp Failure” message appears on page 42 to
troubleshoot the projector.
Off Off The projector isn’t receiving power.
See The projector Power light isn’t lit on page 42 to
troubleshoot the projector.

Projector error states

System administrators can solve or troubleshoot the following projector error states on their own prior
to contacting SMARTTechnical Support. Performing initial troubleshooting on your projector will
reduce the time of a support call.
Your projector doesn’t respond to commands
If your projector doesn’t respond to commands or if it starts to display code after you enter a
command, perform the following procedure.
gTo restart an unresponsive projector
1. Put the projector into Standby mode, and then wait 30 minutes for it to cool down.
2. Disconnect the power cable from the power outlet, and then wait at least 60 seconds.
3. Connect the power cable, and then turn on the projector.
The “Projector Overheated” message appears
If the “Projector Overheated” message appears and the projector enters Standby mode during use,
one of the following issues is occurring:
lThe projector is overheating internally because of blocked air vents.
lThe temperature outside the projector is too high.
gTo resolve the “Projector Overheated” error
1. Put the projector into Standby mode, and then wait 30 minutes for it to cool down.
2. If your room is hot, lower the temperature if possible.
C H A P T E R 6
Troubleshooting your interactive whiteboard system
40