99-00964-20 A0 Maintaining Your UF55 Projector 29
Maintaining Your UF55 Projector This chapter includes methods for properly cleaning and for preventing damage to your SMART Board
interactive whiteboard system.
• Cleaning Your UF55 Projector (this page)
•Transporting Your Projector (page 30)
Cleaning Your UF55 Projecto
WARNING
r
CAUTION • Before you clean the UF55 projector, put the system into Idle mode by pressing the power
button twice on the ECP or remote, and allow the bulb to cool for 30 minutes.
• Do not allow liquids or commercial solvents of any kind to flow into the projector base or
head. Do not use spray cleaners or solvents near any part of the projector, as it may damage
or stain the projector.
IMPORTANT
Follow these guidelines to clean the projector:
• Avoid touching the lens. If necessary, use liquids or commercial solvents (such as glass cleaners) to clean
the lens, but don’t spray them directly on the system.
• If wiping the lens is unavoidable, use protective gloves and dip a lint-free cloth (such as Purestat® PW2004)
in an anti-static solvent (such as Hyperclean® EE-6310).
• Make sure you gently wipe the lens from the center to the outer area.
Spraying the system might spread a chemical mist on some of the projector’s components and lamp, resulting in
damage and poor image quality.
Cleaning a boom-mounted projector may result in a fall and injury.
Wipe the exterior of the projector using a lint-free cloth.