SMC Networks SMCG55 T

EZ Switch 10/100/1000

1. Symptom

Power LED does not light after power on.

Probable Causes

•DC power socket may be defective.

Possible Solutions

•Check for loose connections.

•Check the power outlet by using it for another device.

2. Symptom

Link LED does not light after connection is made.

Probable Causes

•Switch port, network card or cable may be defective.

Possible Solutions

•Check that the switch and attached device are both

powered on.

•Be sure the network cable is connected to both devices.

•Verify that Category 5 or better cable is used for 10/

100 Mbps connections, Category 5 or 5e cable for 1000

Mbps connections, and that the length of any cable

does not exceed 100 meters (328 feet).

•Check the network card and cable connections for

defects.

•Replace the defective card or cable if necessary.

Contents

Main Page Copyright L W IMITED ARRANTY SMC Networks, Inc. 38 Tesla Irvine, CA 92618 C OMPLIANCES FCC - Class B EC Conformance Declaration - Class B Industry Canada - Class B Please read the following safety informa- tion carefully before installing the Switch: Page Veuillez lire fond l'information de la scurit suivante avant d'installer le Switch: Bitte unbedingt vor dem Einbauen des RPU die folgenden Sicherheitsanweisungen durchlesen: Page Warnings and Cautionary Messages Warnings (in German) Environmental Statement End of Product Life Span Manufacturing Materials Documentation Purpose Safety Compliance Underwriters Laboratories Compliance State- ment Contents Page INTRODUCTION Features and Benefits Front Panel RJ-45 Ports Front Panel LEDs SMCGS5 Front and Rear Panels Page INSTALLING THE SWITCH Package Checklist Selecting a Site Instructions Page Page T ROUBLESHOOTING Diagnosing Switch Indicators S PECIFICATIONS EZ Switch 10/100/1000 Page FOR TECHNICAL SUPPORT,CALL: INTERNET Driver updates: World Wide Web: http://www.smc.com/ For Literature or Advertising Response,Call: