Failures
If the washing machine identifies failures in the operation, it reports it immediately. Sound alarm is heard and the display reads ERROR. Number identifies the type of failure.
In some cases you may attempt removing certain failures yourself (see the chart below), and the machine will continue to perform the operation after pressing the START knob (F). The machine signals failures immediately after detecting them and stops the program, except for heater failure, where the machine completes the washing program without heating water (FAILURE 1).
In case the machine signals faults number you have to wait for at least 2 minutes before you can open the door of the washing machine.
Interferences from the ambient (for example electrical wiring) could induce signalization of different faults. In such cases:
-switch the appliance off, and wait for a few seconds;
-switch the appliance back on and repeat the washing program.
If the fault repeats, call authorized service shop.
Failure | Possible cause | Remedy |
|
|
|
The machine does | Machine is not powered. | Check if: |
not work |
| • plug is in the socket, |
(display is not |
| • there is power in the socket, |
illuminated). |
| • the fuse is OK. |
Water does not | Filter is not tightly screwed in. | Tighten the filter properly. |
enter the machine. | Inlet pipe is not tightly | Tighten the inlet pipe. |
| screwed to the machine or to | Affix the outlet pipe to the drain. |
| the water faucet. |
|
| Outlet pipe fell to the floor. |
|
155620
29
