Smeg B70CMSX5 Fitting the rear splash-back, Operation at 380-415V 3N~ use a H05RR-F / H05RN-F

Models: B70CMSX5

1 16
Download 16 pages 15.95 Kb
Page 16
Image 16
Operation at 380-415V 3N~: use a H05RR-F /H05RN-F /

Instructions for the Installer

The appliance has a terminal board on its rear. Make the electrical connection in accordance with the wiring diagram shown below.

To access the terminal board, remove the guard on the rear.

Operation at 380-415V 3N~: use a H05RR-F /H05RN-F /

H05V2V2-F five-wire cable (cable of 5 x 2.5 mm2 on 90 cm model or 5 x 1.5 on 60 cm model).

Operation at 380-415V 2N~: use a H05RR-F /H05RN-F /

H05V2V2-F four-wire cable (cable of 4 x 4 mm2 on 90 cm model or 4 x 2.5 on 60 cm model).

Operation at 220-240 V~: use a H05RR-F / H05RN-F / H05V2V2-F

three-wire cable (cable of 3 x 6 mm2 on 90 cm model or 3 x 6 on 60 cm model).

The earth wire (yellow-green) must be at least 20 mm longer than the other wires at the end for connection to the appliance.

The power supply cable must be fitted with a suitable five-pin plug (see technical data plate) or, for appliances operating on 220-240 V, a three-pin plug. The power supply plug and wall socket must be of the same type and compliant with the relevant regulations. Check that the appliance is earthed appropriately. Before putting the appliance into operation, check that the power supply line is properly earthed. The use of adapters or junctions is not recommended.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR INJURY OR DAMAGE CAUSED BY

FAILURE TO COMPLY WITH THE ABOVE REGULATIONS

13.2 Fitting the rear splash-back

Unscrew the nuts B.

Place the splash-back on the hob, aligning the rods C with the holes D.

Fix the splash-back to the hob by tightening the screws A.

13.3 Positioning and levelling the appliance (depending on model)

After making the electrical and gas connections, level the the appliance on the ground by means of its four adjustable feet. For good cooking results, the appliance must be properly levelled. Depending on the model you have purchased, the foot height adjustment range may vary from 70 to 95 mm and from 110 to 160 mm. These heights refer to the distance between the highest point of the foot (fixed part) and the lowest point (movable part which rests on the floor).

86

914772936/ A

Page 16
Image 16
Smeg B70CMSX5 manual Fitting the rear splash-back, Positioning and levelling the appliance depending on model