Smeg CE6IPX manual Installing the Appliance, Electrical connection

Instructions for the installer

15.INSTALLING THE APPLIANCE

The appliance must be installed by a qualified technician and according to the standards in force.

This appliance may be installed next to a wall which is higher than the appliance, with a minimum distance of 5 cm from the side of the appliance, as shown in drawings A and B showing the correct installation conditions. Any wall cupboards or shelves must be at a distance of at least 75 cm above the work surface.

A)

Built-in appliance

15.1Electrical connection

B)

Free-standing appliance

Make sure the voltage and the cross-section of the power cord match the specifications indicated on the rating plated positioned in the storage compartment. Do not remove this plate for any reason.

If the appliance is connected to the supply by means of a fixed connection, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm located near the appliance and in an easily reachable position.

Connection to the supply may be fixed or with plug and socket. In the latter case the plug and socket must be suitable for the cable employed and conform with the regulations in force. Regardless of the type of connection, the appliance absolutely must be earthed. Before connection make sure that the supply line is suitably earthed. Avoid the use of reducers, adapters or shunts which may cause overheating.

59