Installation, Removal of transport bracket

6GB10055.fm Page 15 Monday, August 2, 2004 12:33 PM

INSTALLATION

The washing machine is fitted with a transport bracket to avoid any possible damage during transport.

Before using the washing machine, the transport bracket at the back MUST be removed.

1.Unscrew the two screws A and the four screws B with a flat screwdriver or a No. 8 hex nut box spanner.

2.Remove the transport bracket.

3.Replace the four outer screws B on the machine and tighten them.

4.Remove the two seals C from the hose holder and clip them into the openings of the machine D.

Note: do not forget to replace and tighten the four outer screws.

GB 15

Image 15

Contents

Contents Remove the transport bracket Before Using the Washing MachineInstall the washing machine Remove the packaging and check Electrical connection First Wash Cycle Precautions and General Recommendations Description of the Washing Machine Preparation of the WashingSort the laundry Stain removal Dyeing and bleachingStarching Open the machine lid Loading the laundry Choice of the right detergents and additives Detergents and AdditivesDosage Filling up with detergents and additives Programme Selection Cleaning the Foreign Body Trap Detergent dispenser Draining Residual Water Water inlet hose filter Check and clean regularly at least two or three times a year Washing machine stops during the programme Water inlet hosesWashing machine does not start, no lamp lights up Washing machine does not start, but the pilot lamp is on Water Stop fault may have been triggered by Water stop fault depending on model Specify Before contacting After-Sales Service Removal of transport bracket Connect the water inlet hose Adjust the feet Connect the water drain hose Water stop anti-flooding system Fuse replacement Valid Only For Great Britain And IrelandPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A GB K 400 TL No spin button Programme Temperature Load Water EnergyMin Terminate the Rinse Hold option