Installation Instructions
STEP 11 INSTALL DISPENSER TRIM
Skip this step is you are installing a stainless steel wrapped or a
There are two dispenser trims shipped with your refrigerator. Select the appropriate trim for your application.
Framed | Overlay |
Panel | Panel |
Trim | Trim |
Compare the dispenser trims. Note that the inside depth of the frames are different. Choose the trim with less depth for framed panels, choose the deeper one for overlay panels.
Dispenser trim fit over the custom panel depends on correct panel thickness. See pages 7 and 8 for panel construction information.
•Press and snap the dispenser trim into the dispenser recess on the refrigerator door.
If an excessive gap exists around the dispenser trim or if the panel fits loosely in the door frame, foam tape may be applied to help improve the fit. Remove the trim and panel and apply foam tape to the door around the dispenser and in the corners.
STEP 12 CONNECT WATER SUPPLY
Refrigerator | House |
Water Supply | Water Supply |
•Locate and bring tubing to the front of the cabinet.
•Turn the water on to flush debris from line. Run about a quart of water through tubing into a bucket, then
Copper Tubing:
•Slip a 1/4" nut and ferrule (provided) over both ends of the copper tubing. Insert tube into the union fitting on the unit and tighten nut to union.
•Turn on the water to check for leaks.
GE SmartConnect™ Tubing:
•Insert the molded end of the tubing into the refrigerator connection. Tighten the compression nut until it is just hand tight.
•Tighten one additional turn with a wrench. Overtightening can cause leaks!
•Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not interfere with toekick installation.
18
