Installation Instructions
STEP 7 SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step for
The refrigerator must be secured to prevent tipping.
•Raise the grille panel to access case trim.
•Drill hole in trim and drive screw through the trim into adjacent cabinet.
•Follow the same procedure on the opposite side.
Raise Grille Panel
to Stop Position
Drive Screws
Through Case Trim Into
Adjacent Cabinets
STEP 8 ADJUST DOOR SWING
NOTE: This refrigerator has a
for your installation situation.
90˚ 130˚
Interior
Door
Hinge
•Open the door to view the bottom hinge. Note the door stop pin locations. The pin is factory installed in the 130° position.
•Close the door. From below, use pliers to unscrew the door stop and reinstall into the 90° position.
STEP 9 INSTALL GRILLE PANEL
To insert framed or overlay panel into the grille:
• Raise the grille panel to stop position.
Loosen | Raise | Loosen |
Grille | ||
Side | Panel | Side |
Trim |
| Trim |
Screw |
| Screw |
| Adjust Nut Below |
|
| Spring to Accommodate |
|
| Panel Weight |
|
•Loosen screws on side trim behind frame. Remove bottom trim.
CAUTION: Metal panel may be slippery. Grip metal panel firmly, so the panel does not slip out of the frame and cause personal injury or damage to the frame.
PRUDENCE : Le panneau en métal peut bêtre glissant. Tenir fermement le panneau en métal, de manière à ce que le panneau ne glisse pas en dehors du cadre en provoquant des blessures corporelles ou des dommages au cadre.
•Slide panel over the metal backer panel and into the trim.
•If necessary, tap with a wood block until panel slips under the top trim piece.
•Reassemble bottom trim. Tighten screws.
•Adjust the hinge spring to accommodate the panel weight, if necessary.
14