Installation Instructions
STEP 10A INSTALL OVERLAY PANELS
Handle
Trim
Move
Forward
For 3/4"
Panel
Install door panels:
Door Trim
Refrigerator
Door
Supplied Handle
Shown in Overlay
Panel Position
•Open door to 90°. Remove the 6 Phillips head screws from the door handle.
•Remove handle. Retain all screws.
•Remove 6 screws holding trim, lift off trim. Retain screws.
•Slide overlay panel into the door trim.
Dispenser Models Only:
•The dispenser controls protrude beyond the face of the freezer door. To avoid damage to the dispenser, the trim at the top of the door should be removed.
•Remove the screws holding the top trim in place.
•Place the assembled freezer panel into the bottom channel and slide into the hinge side trim.
•Reinstall the top trim piece with screws.
•There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screws in the REAR screw holes.
•Secure the handle to the door using the FRONT screw holes.
•Follow the same procedures to install the opposite panel.
•Check to be sure handles are evenly aligned with each other at the top. To adjust, loosen handle screws and slide up or down. Tighten screws.
Use Front Holes to Secure Handle
Use Rear Holes to Secure Trim
16
