Installation Instructions
STEP 10 INSTALL 1/4” FRAMED PANELS
Install door panels:
•Open door to 90°. Remove the 6 Phillips head screws from the door handle.
•Remove handle. Retain all screws.
•Remove 6 screws holding trim, lift off trim. Retain screws.
•Slide framed panel into the door trim.
Dispenser Models Only:
•The dispenser controls protrude beyond the face of the freezer door. To avoid damage to the dispenser, the trim at the top of the door should be removed.
•Remove the screws holding the top trim in place.
•Place the freezer panel into the bottom channel and slide into the hinge side trim.
•Reinstall the top trim piece with screws.
•There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screws in the FRONT screw holes.
•Secure the handle to the door using the REAR screw holes.
•Follow the same procedures to install the opposite panel.
•Check to be sure handles are evenly aligned with each other at the top. To adjust, loosen handle screws and slide up or down. Tighten screws.
NOTE: Aluminum cover trim is supplied for use with custom handles on overlay panels. It is not intended for use with 1/4" panels. Discard the cover trim when using 1/4" framed panels.
Go to Step 9A for Overlay Panels
Handle | Door Trim |
Trim |
|
Refrigerator
Door
Supplied
Handle Shown
in 1/4" Panel
Position
Use Front Holes to Secure Trim
Use Rear Holes
to Secure Handle
15