Instructions for the installer
6.2Fixing to the electric model support structure
Create an opening with the dimensions |
| |
shown in the figure in the top surface of the |
| |
counter, keeping a minimum distance of 50 |
| |
mm from the rear edge. |
| |
The lower part of the casing must be fully |
| |
accessible after the appliance has been |
| |
installed. This appliance can be mounted |
| |
against walls higher than the work surface |
| |
on condition that a distance of "X" be kept | 1) | |
between the appliance and the wall as | ||
| ||
shown in the figure so as to avoid damage |
| |
from overheating. |
|
Make sure that there is a minimum of 750 mm between the hob ring flames and any shelves placed directly above them (Fig. 1). Furthermore, this kind of appliance needs a milling on the hob top of 3 mm in depth; the measurements are indicated in figure 4 (detail A of figure 2).
Before positioning the hob, the supplied adhesive sponge “E” should be spread out flat over the milling surface (fig. 2). Carry out this operation by supporting the hob on the isolating seal and using screws and clamping brackets (Fig. 3 sequence) to fix the hob to the support structure, in order to obtain the complete flatness. The small brackets in figure 3 are only positioned after having mounted the hob.
3)
2) | 4) |
|
If laminated surfaces are used, it is advisable to spread a layer of
Important: Other types of installation are possible if supervised by the manufacturer!
31