Smeg PGA64, gas cooktop manual Instructions for the installer, 6.3Electrical connection

Instructions for the installer

6.3Electrical connection

Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason.

The plug at the end of the supply cable and the wall socket must be of the same type and must conform to the applicable legislation on electrical installations. Make sure that the supply line is suitably earthed.

Fit power line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm in an easily accessible position close to the hob.

Avoid the use of adapters and shunts.

If the power cable is replaced, the cross- section of wires in the new cable must be no less than 0.75 mm2 (3 x 0.75 cable), remembering that the end for connection to the appliance must have a longer earth wire (yellow/green)

,longer by at least 20 mm. Only use a H05V2V2-F or similar resistance cable to the maximum temperature of 90°C. Its replacement must be carried out be a specialised technician who must carry out the network connection following the diagram below.

L = brown

N - blue

= yellow/green

The manufacturer cannot be held liable for damage to persons or things caused by non-observance of the above directions or by interference with any part of the appliance.

33