User instructions
FAULT
E7
E8
E9
DESCRIPTION
Turbine
The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the
Alternate washing system malfunction
Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the
Water intake system malfunction
Contact the
•The E1, E2, E3, E4, E8, E9 alarms provoke the “forcing” to end cycle of the running program.
•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.
•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.
If the fault persists, call the authorised Technical Service Centre.
TECHNICAL DATA
Width |
| 597 ⎟ 599 mm |
|
|
|
Depth measured flush with the |
| Free standing: 600 mm |
outer edge of the control panel |
| |
|
|
|
Height |
| Free standing from 850 mm to 870 mm |
| ||
|
| |
|
|
|
Capacity |
| 14 Standard place settings |
|
|
|
Water supply pressure |
| min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) |
|
|
|
Electrical characteristics |
| See rating plate |
33