Smeg SCB64MPX5, SCB64MPX6 manual Fitting the rear splash-back, Instructions for the Installer

Instructions for the Installer

Operation at 380-415V 3N~: use a H05RR-F five-wire cable (cable of 5 x 2.5 mm2).

Operation at 380-415V 2N~: use a H05RR-F four-wire cable (cable of 4 x 4 mm2).

Operation at 220-240 V~: use a H05RR-F three-wire cable (cable of 3 x 6 mm2).

The earth wire (yellow-green) must be at least 20 mm longer than the other wires at the end for connection to the appliance.

The power supply cable must be fitted with a suitable five-pin plug (see technical data plate) or, for appliances operating on 220-240 V, a three-pin plug. The power supply plug and wall socket must be of the same type and compliant with the relevant regulations. Check that the appliance is earthed appropriately. Before putting the appliance into operation, check that the power supply line is properly earthed. The use of adapters or junctions is not recommended.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR INJURY OR DAMAGE CAUSED BY FAILURE TO COMPLY WITH THE ABOVE REGULATIONS

14.2 Fitting the rear splash-back

•Unscrew the nuts B.

•Place the splash-back on the hob, aligning the rods C with the holes D.

•Fix the splash-back to the hob by tightening the screws A.

14.3 Positioning and levelling the appliance (depending on model)

After making the electrical and gas connections, level the the appliance on the ground by means of its four adjustable feet. For good cooking results, the appliance must be properly levelled. Depending on the model you have purchased, the foot height adjustment range may vary from 70 to 95 mm and from 110 to 160 mm. These heights refer to the distance between the highest point of the foot (fixed part) and the lowest point (movable part which rests on the floor).

62