Smeg SCDK380X Instructions for the installer, Installing The Appliance, 13.1Electrical connection

Instructions for the installer

13.INSTALLING THE APPLIANCE

13.1Electrical connection

The I.D. plate with technical data, serial number and brand name is positioned visibly on the oven door frame.

The plate must not be removed.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a fixed connection is being used, fit the power line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm, in an easily accessible position close to the appliance.

If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and burns.

Operation at 220-240 V~: use an H05RR-F type three-core

cable (3 x 1.5 mm2).

The end to be connected to the appliance must be an earth wire (yellow-green) at least 20 mm longer.

13.2 Positioning the oven

The oven is designed for mounting into any piece of furniture as long as it is heat-resistant. Proceed according to the dimensions shown in Figures 1, 2 and 3. For installing under a work top, follow the dimensions given in Figure 1-3. For installing under a work top with combined cooking hobs, ensure a minimum clearance from any side walls of at least 110 mm as shown in Figure 1. When installing in tall units, comply with the dimensions shown in figure 1-2, bearing in mind that the top/rear of the unit must have an opening 80-90 mm deep. Tighten the 4 screws A inside the frame (fig. 1). For installing beneath a countertop hob, allow for a rear and bottom clearance as shown in Figure 1 (ref. B). See the relevant instructions for fitting and securing the hob.

27