Instructions for the user
7.7.2 Automatic cooking
Automatic cooking is the function which allows a cooking operation to be started at a set time and then ended after a specific length of time set by the user.
Select a cooking function, set the cooking temperature required or leave the preset temperature (see paragraph “7.6 Selecting a function”) and press
PT1 twice. The display will show the 
figures and the 
symbol (flashing).
Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to 23:59).
For safety reasons, when setting automatic cooking the user must first program a cooking duration and then set the cooking start time. It is not possible to set the cooking start time only, without setting the cooking duration.
After setting the duration, press PT1 once.
The 
symbol and the current time will appear on the display.
Turning PT1 to the right increases the time, allowing the cooking start time required to be set.
A few seconds after the required duration is set, the 
and 
symbols will stop flashing, and the oven will start to wait for the starting time set. At the end, the word STOP will appear on DSP1, cooking will stop and a buzzer will sound; press PT1 once to deactivate it.
If you wish to continue cooking beyond the set time, press PT1 again. The oven will restart normal operation with the temperature settings selected previously.
PT2 has to be pressed to switch the oven off completely.
Modifying the data set
Once automatic cooking has started, its duration can be changed.
When the 
and 
symbols are steady and cooking is in progress, or the oven is in
symbol starts flashing and PT1 can be turned to change the set duration.
Press PT1 again; the 
symbol goes out, the 
symbol will start to flash, and the cooking start time will be displayed on DSP1. The cooking start time can be increased or decreased by turning PT1.
A few seconds after the last change, the 
and 
symbols will appear (in steady mode) on DSP1 and automatic cooking will restart with the new settings.
Once cooking has been programmed, before it starts, the function symbol will remain on, as will the symbols 
, 
.
50
