Instructions for the user
10.5 what to do if...
The oven display is full off
The oven does not heat up
The controls do not respond.
The cooking times are longer than those indicated in the table.
After the automatic “pyrolysis” cleaning cycle (only on some models) it is not possible to select a function.
The display shows ERR 4
(on pyrolytic models only)
If the door is opened during a ventilated function, the fans stop.
•Check the mains power supply.
•Check whether an omnipolar switch upstream from the oven feed line is in the “ON” position.
•Check whether the “showroom” mode has been set, for further details see paragraph “Secondary menu” on page 51.
•Check whether the “child
•Check whether the “2300 W” mode has been set, for further details see paragraph “Secondary menu” on page 51.
•Verify whether the interlock device has switched off. If it has not, the oven has a protection device that does not allow functions to be selected while the interlock device is active. This is because the temperatures inside the oven are still too high to permit any type of cooking.
•The interlock device has not hooked up to the door properly. These might be because the door was accidentally opened during its activation. Switch off the oven and switch it on again waiting a few minutes before selecting a new cleaning cycle.
•This is not a fault. It is a normal operation of the appliance, useful when cooking foods in order to avoid excessive heat escaping. When the door is closed, the oven will return to normal operation.
If the problem has not been resolved or for other types of faults, contact your local technical assistance centre.
68