Manuals / Smeg / Kitchen Appliance / Oven

Smeg SE365MF-5 Installing The Appliance, Electrical connection, Instructions for the Installer

Models: SE365MF-5

1 28

Download 28 pages 40.05 Kb

Page 25

Image 25

Instructions for the Installer

13.INSTALLING THE APPLIANCE

13.1Electrical connection

The nameplate with the technical data, serial number and mark is in a visible position on the oven door frame.

The nameplate must never be removed.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a permanent connection is used, the appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.

If a socket and plug connection is used, check that they are of the same type. Do not use reducers, adapters or junctions since they may cause overheating or burns.

Operation at 220-240 V~: use a H05RR-Fthree-wire cable (cable of 3 x 1.5 mm2).

The earth wire (yellow-green) must be at least 20 mm longer than the other wires at the end for connection to the appliance.

Page 25

Image 25

Smeg SE365MF-5 manual Installing The Appliance, Electrical connection, Instructions for the Installer

Contents

DISPOSAL INSTRUCTIONS - OUR ENVIRONMENT POLICY Table of ContentsDESCRIPTION OF FRONT PANEL CONTROLS 1. PRECAUTIONS FOR USE Precautions for Use2. DISPOSAL INSTRUCTIONS - OUR ENVIRONMENT POLICY Disposal instructions3. SAFETY PRECAUTIONS Safety PrecautionsNEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD NEVER ATTEMPT TO REPAIR THE APPLIANCEInstructions for the User 5. BEFORE INSTALLATION4. GET TO KNOW YOUR OVEN Instructions for the User 6. DESCRIPTION OF FRONT PANEL CONTROLSFUNCTION SELECTOR KNOB THERMOSTAT KNOBInstructions for the User HOB CONTROL KNOB THERMOSTAT LIGHTDUAL HEATING HOB CONTROL KNOB IMPORTANT ON MODELS WITH INTEGRATED CONTROLS7. ELECTRONIC PROGRAMMER 7.1 Setting the timeLIST OF FUNCTIONS Instructions for the User7.3 Automatic cooking 7.2 Semiautomatic cooking7.4 Minute minder end of cooking time press the keyAfter the setting, to display the time left press the key 7.6 Adjusting the buzzer volume7.5 End of cooking 7.7 Stopping the buzzer8.1 Precautions and General Advice 8. USING THE OVENInstructions for the User 8.3 Inside light Depending on models 8.2 Cooling fan system on some models onlyInstructions for the User Not all accessories are provided on some models 9. ACCESSORIES AVAILABLEOptional accessories Chromium-plated gripper useful for removing hot shelves and trays10.1 Conventional cooking 10. COOKING ADVICE50 ÷ 250 C 10.2 Hot air cooking10.4 Grilling 10.3 Delicate cooking10.5 Hot air grilling 200 CInstructions for the User 10.6 ThawingFUNCTION SELECTOR THERMOSTATGRILLING CONVENTIONAL COOKING10.7 Recommended cooking tables Instructions for the UserInstructions for the User HOT AIR COOKINGCONFECTIONERY 11.1 Cleaning stainless steel 11. CLEANING AND MAINTENANCE11.2 Routine daily cleaning Never use a jet of steam for cleaning the inside of the oven11.5 Cleaning the oven with self-cleaning liners on some models only 11.4 Cleaning the oven11.5.1 Using the self-cleaning liners 11.5.2 Maintenance of self-cleaning liners11.5.3 Removing the self-cleaning liners 11.6 Cleaning the door glazingInstructions for the User 12. EXTRAORDINARY MAINTENANCE Instructions for the Installer12.1 Changing the light bulb Use only light bulbs approved for ovens T 300C12.3 Removing the gasket 12.2 Removing the doorInstructions for the Installer 13.1 Electrical connection 13. INSTALLING THE APPLIANCEInstructions for the Installer Operation at 380-415V2N~ use a H05RR-F / H05RN-F four-wire cable Operation at 220-240 V~ use a H05RR-F / H05RN-F three-wire cableOperation at 380-415V3N~ use a H05RR-F / H05RN-F five-wire cable cable of 3 x 4 mm2Instructions for the Installer 13.2 Positioning the ovenInstructions for the Installer 13.3 Hob-oven connection