User instructions
6. Troubleshooting
E1
E3
E4
E5
E6
The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings:
FAULTDESCRIPTION
The dishwasher’s
This alarm is triggered in the event of a water leak in the dishwasher. In such circumstances the technical service centre must be called.
The dishwasher fails to heat the water.
Repeat the wash program. If the problem persists, contact the customer technical service centre.
The temperature monitoring system has failed.
Switch the dishwasher off, switch it back on and restart the washing program.
If the alarm recurs, call the After Sales Service.
The dishwasher fails to draw water.
Ensure the plumbing connections are in order and that the water supply tap is open.
The dishwasher fails to drain.
Check that the drain hose is not kinked, the siphon is not obstructed and the filters are not clogged.
Light off | Light on | Light flashing |
If an alarm occurs the appliance interrupts the program in progress and signals a fault.
•In case of E1, E3 and E4, the washing program must be set again to continue.
•In case of E5 and E6, simply open and close the door to continue (once the cause of the fault has been illuminated).
TECHNICAL DATA
Width
Depth measured flush with the outer edge of the control panel
597 ⎟ 599 mm
570 mm
Height |
| from 820 mm to 870 mm |
|
|
|
Capacity |
| 14 Standard place settings |
|
|
|
Water supply pressure |
| min. 50 – max. 900 KPa (min. 0.5 – max. 9 bar) |
|
|
|
Electrical characteristics |
| See rating plate |
45
