![](/images/new-backgrounds/1262309/262309101x1.webp)
Appendix
A. Troubleshooting
Status LED
After powering up, the Network Camera performs a
Condition | LED color |
|
|
During | Blink in interchanged green and red |
|
|
Ethernet signal is lost | Steady red till Ethernet is detected |
|
|
Before network is setup | Steady green till IP address is confirmed |
|
|
After network is setup | Blink green every second |
|
|
Any hardware failure | Other patterns |
|
|
Reset and restore
Restore the factory defaults
will erase any previous settings. Reset or restore the system after power on.
There is a button hidden in the pinhole beside the Ethernet socket. It is used to reset the system or restore the factory default settings. Sometimes resetting the system can make the system back to normal state. If the system still has problems after reset, restore the factory settings and install again.
RESET: Poke the wrench to click on the button.
RESTORE: 1. Poke the wrench to press on the button continuously.
2.Wait for
3.Withdraw the wrench as soon as the second
- 50 -