User instructions, Technical Data, Width

User instructions

TECHNICAL DATA

Width

Depth measured flush with the outer edge of the control panel

Height (depending on models)

Capacity

Water supply pressure

Electrical characteristics

597 ⎟ 599 mm

550 mm

from 820 mm to 870 mm from 860 mm to 910 mm

12 Standard place settings

min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)

See rating plate

Page 34

Image 34

Smeg STA6248, STA6249 User instructions, Technical Data, Width, Height depending on models Capacity Water supply pressure

Contents

GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS Contents USES OTHER THAN THOSE DESCRIBED ABOVE Safety instructions1. Safety and operating instructions NEVER BE REMOVED THIS DISHWASHER MUST BE USED BY ADULTS AQUASTOP MODELS APPLIANCE 2. Installation and hook-up Installation instructions2.1 Water supply connection CONNECTING TO THE WATER SUPPLY DRAIN CONNECTION NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD 2.2 Electrical connection and precautionsIF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD Fuse replacement FOR GREAT BRITAIN ONLY SELECTED PROGRAM INDICATOR LIGHTS User instructions3. Description of the controls 3.1 Upper panel DELAYED START BUTTON on some models only SETTING THE WASHING PROGRAM AND SWITCHING ONDELAYED START LIGHTS on some models only Only run the soak program with half loads Before starting a washing program make sure that 3.2 Washing programsThe correct amount of detergent has been added to the dispenser TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT CANCELLING THE CURRENT PROGRAMCHANGING THE PROGRAM TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT END OF CYCLE REMOVING THE DISHES 4. Operating instructions 4.1 Using the water softening system ADJUSTING THE WATER SOFTENING SYSTEM 4.2 Using the rinse aid and detergent dispensers WATER HARDNESS TABLE ADJUSTING THE RINSE AID DISPENSER SETTING ADDING THE RINSE AID ADDING THE DETERGENT During the washing cycle, the dispenser will be opened automatically 3/1 Products 4.3 General warnings and recommendationsCorrect loading of the dishes helps ensure optimal washing results Dishes and objects in copper, tin, zinc or brass these tend to stain LOWER BASKET 4.4 Using the basketsLOADING THE LOWER BASKET CUTLERY BASKET UPPER BASKET LOADING THE UPPER BASKET ADJUSTING THE UPPER BASKET Version C with adjustment in three positions on both sides CLEANING THE SPRAY ARMS 5. Cleaning and maintenanceCLEANING THE WATER INTAKE FILTER 5.1 General warnings and recommendations PROLONGED DISUSE CLEANING THE FILTER UNITGENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE Fill the rinse aid dispenser Shut off the water supply tap BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE TROUBLESHOOTING MINOR PROBLEMSIf the dishes are not being cleaned properly, check that Reconnect the water intake hose and open the tap again If the dishes show signs of streaking, staining, etc., check that If the dishes fail to dry or remain dull, check thatIf there are visible traces of rust inside the tank Safety level 6. TroubleshootingFAULT E1 E2 E3 E4 E5 E6 Alternate washing system malfunction E7 E8 E9Turbine flow-regulator malfunction Water intake system malfunction Width TECHNICAL DATAElectrical characteristics Height depending on models Capacity Water supply pressure

Smeg STA6248, STA6249 User instructions, Technical Data, Width, Electrical characteristics

Models: STA6249 STA6248

TECHNICAL DATA

Width

Height (depending on models)

Electrical characteristics